172mm 5.5 0.5 264 24 7,300 2,400 6,400 1,900 100 0 9CR5748P9G001 1 8 5 . 5 6 3 6 1 9 4 . 3 1 4 0 0 1 5 2 5 . 6 2 0 . 6 1 83 54 48 36 to 72 10 to 70 ? 40,000 172 150 102 mm 4- 4.5 55.5 162 ? 0.5 168 147 55.5 ? 9.5 high air flow and static pressure ~excellence in delivering high airflow and static pressure made possible by our industry?s first counter rotating fan that has a 172 mm diameter. ~its cooling performance is more than that of four standard fans* ( 172 x 150 x 51 mm). yjust one unit powerfully cools your equipment, ygreatly helping downsize the equipment. * two sets of two tandem-placed ? san ace 172 ? 172 150 51 mm; model no. 9gv5748p5h03 cr type ? material kkkkkkkkkkkkkkkkkkkkkkkkkk ? expected life kkkkkkkkkkkkkkkkkkkkk ? motor protection system kkkkkkkkkk ? dielectric strength kkkkkkkkkkkkkkkk ? sound pressure level (spl) kkkkkkkk ? operating temperature kkkkkkkkkkkk ? storage temperature kkkkkkkkkkkkkk ? lead wire kkkkkkkkkkkkkkkkkkkkkkkk ? mass kkkkkkkkkkkkkkkkkkkkkkkkkkkkk frame : aluminum, impeller : plastics (flammability: ul94v-0) varies for each model (l10: survival rate: 90% at 60 ? , rated voltage, and continuously run in a free air state) current blocking function and reverse polarity protection 50/60 hz, 500vac, 1 minute (between lead conductor and frame) expressed as the value at 1m from air inlet side varies for each model (non-condensing) 30 ? to 70 ? non-condensing inlet : redy ? blackysensor: yellow control: brown outlet : orangey ? grayysensor: purple control: white approx. 1,600g speci?cations features counter rotating fan 172 1 62 ? 0.5 1 72 ? 0.8 (1 0) (1 0) 4- 4.5 ? 0.3 7 .5 ? 0.4 1 02 ? 1 7 .5 ? 0.4 1 50 ? 0.8 4- 4.5 ? 0.3 55.5 ? 55.5 ? a wg22 ul1430 +30 30 0 0 +30 30 0 0 counter rotating fan 172mm [m 3 /min] [cfm] [pa] [inchh 2 o] | db(a) [ ? ] [ h ] model no. rated voltage | v operating voltage range |v rated current | a rated input | w common speci?cations rated speed | min -1 i n l e t o u t l e t max. air flow max. static pressure spl operating temperature expected life n o t e ) pwm duty cycle | % note : pwm frequency 25khz rotating direction rotating direction air flow direction inlet side outlet side inlet side , outlet side mounting hole mounting hole reference dimension of mounting holes and vent opening (unit : mm) dimensions (unit : mm) l e a d w i r e 1-15-1, kita-otsuka, toshima-ku,tokyo 170-8451, japan. phone :+ 81 3 3917 5151 http://www.sanyodenki.com the names of companies and/or their products speci?ed in this catalog are the trade names, and/or trademarks and/or registered trademarks of such respective companies. speci?cations are subject to change without notice. ? the products shown in the catalog are subject to japanese export control law. diversion contrary to the law of exporting country is prohibited. ? to protect against electrolytic corrosion that may occur in locations with strong electromagnetic noise, we provide fans that are unaffected by electrolytic corrosion. catalog no. c1012 b 001 ?12.08 www.datasheet.net/ datasheet pdf - http://www..co.kr/
9CR5748P9G001 pa inch h 2 o 9CR5748P9G001 0 0 100 pa inch h 2 o 0 0 100 200 300 400 500 600 700 1,900min -1 172 150 102 mm 172 dc 48v 9CR5748P9G001 0 300 100 0 400 500 600 700 200 5 10 15 20 50% 0% cfm cfm m 3 /min m 3 /min 5 10 15 20 48v 36v 72v 7,300min -1 6,400min -1 1,000 2,000 3,000 4,000 5,000 6,000 7,000 8,000 2,400min -1 t t 1 v il v ih t 100 t1 t 1 input signal wave form v ih =4.75v to 5.25v v il =0v to 0.4v pwm duty cycle % = pwm frequency 25 khz = source current isource : 1ma max. at control voltage 0v sink current isink : 1ma max. at control voltage 5.25v control terminal voltage : 5.25v max. (open circuit) when the control lead wire is open, speed is same as one at 100% pwm duty cycle. this fan speed should be controlled by pwm input signal of eit her ttl input or open collector, drain input. t 0 t 1 0v v ol v oh t 2 t 3 t 4 t 1 ? 4 1/4 t 0 t 1 ? 4 1/4 t 0 1 60/4n sec n 1 fan speed min -1 one revolution in case of steady running v ce 1 72v max. i c 1 1 0 m a m a x . | v o l 1 v c e s a t 1 0 . 6 v m a x . ic v ce output circuit : open collector output waveform need pull-up resistor inside of dc fan sensor output pull-up resistor sensor isource isink control pwm input signal dc fan input voltage inside of dc fan ~ pwm duty cycle ~ operating voltage range static pressure air ?ow air ?ow pwm duty cycle 100 ? pwm duty cycle 100% air flow - static pressure characteristics pwm duty - speed characteristics example speed min -1 pwm duty cycle % voltage dc48v pwm frequency 25khz inlet side outlet side speci?cations for pulse sensors connection schematic pwm input signal example 0 200 400 600 800 1 ,000 1 , 200 1 , 400 1 , 600 1 2 3 4 5 6 static pressure 0 200 400 600 800 1 ,000 1 , 200 1 , 400 1 , 600 1 2 3 4 5 6 www.datasheet.net/ datasheet pdf - http://www..co.kr/
9CR5748P9G001 pa inch h 2 o 9CR5748P9G001 0 0 100 pa inch h 2 o 0 0 100 200 300 400 500 600 700 1,900min -1 172 150 102 mm 172 dc 48v 9CR5748P9G001 0 300 100 0 400 500 600 700 200 5 10 15 20 50% 0% cfm cfm m 3 /min m 3 /min 5 10 15 20 48v 36v 72v 7,300min -1 6,400min -1 1,000 2,000 3,000 4,000 5,000 6,000 7,000 8,000 2,400min -1 t t 1 v il v ih t 100 t1 t 1 input signal wave form v ih =4.75v to 5.25v v il =0v to 0.4v pwm duty cycle % = pwm frequency 25 khz = source current isource : 1ma max. at control voltage 0v sink current isink : 1ma max. at control voltage 5.25v control terminal voltage : 5.25v max. (open circuit) when the control lead wire is open, speed is same as one at 100% pwm duty cycle. this fan speed should be controlled by pwm input signal of eit her ttl input or open collector, drain input. t 0 t 1 0v v ol v oh t 2 t 3 t 4 t 1 ? 4 1/4 t 0 t 1 ? 4 1/4 t 0 1 60/4n sec n 1 fan speed min -1 one revolution in case of steady running v ce 1 72v max. i c 1 1 0 m a m a x . | v o l 1 v c e s a t 1 0 . 6 v m a x . ic v ce output circuit : open collector output waveform need pull-up resistor inside of dc fan sensor output pull-up resistor sensor isource isink control pwm input signal dc fan input voltage inside of dc fan ~ pwm duty cycle ~ operating voltage range static pressure air ?ow air ?ow pwm duty cycle 100 ? pwm duty cycle 100% air flow - static pressure characteristics pwm duty - speed characteristics example speed min -1 pwm duty cycle % voltage dc48v pwm frequency 25khz inlet side outlet side speci?cations for pulse sensors connection schematic pwm input signal example 0 200 400 600 800 1 ,000 1 , 200 1 , 400 1 , 600 1 2 3 4 5 6 static pressure 0 200 400 600 800 1 ,000 1 , 200 1 , 400 1 , 600 1 2 3 4 5 6 www.datasheet.net/ datasheet pdf - http://www..co.kr/
172mm 5.5 0.5 264 24 7,300 2,400 6,400 1,900 100 0 9CR5748P9G001 1 8 5 . 5 6 3 6 1 9 4 . 3 1 4 0 0 1 5 2 5 . 6 2 0 . 6 1 83 54 48 36 to 72 10 to 70 ? 40,000 172 150 102 mm 4- 4.5 55.5 162 ? 0.5 168 147 55.5 ? 9.5 high air flow and static pressure ~excellence in delivering high airflow and static pressure made possible by our industry?s first counter rotating fan that has a 172 mm diameter. ~its cooling performance is more than that of four standard fans* ( 172 x 150 x 51 mm). yjust one unit powerfully cools your equipment, ygreatly helping downsize the equipment. * two sets of two tandem-placed ? san ace 172 ? 172 150 51 mm; model no. 9gv5748p5h03 cr type ? material kkkkkkkkkkkkkkkkkkkkkkkkkk ? expected life kkkkkkkkkkkkkkkkkkkkk ? motor protection system kkkkkkkkkk ? dielectric strength kkkkkkkkkkkkkkkk ? sound pressure level (spl) kkkkkkkk ? operating temperature kkkkkkkkkkkk ? storage temperature kkkkkkkkkkkkkk ? lead wire kkkkkkkkkkkkkkkkkkkkkkkk ? mass kkkkkkkkkkkkkkkkkkkkkkkkkkkkk frame : aluminum, impeller : plastics (flammability: ul94v-0) varies for each model (l10: survival rate: 90% at 60 ? , rated voltage, and continuously run in a free air state) current blocking function and reverse polarity protection 50/60 hz, 500vac, 1 minute (between lead conductor and frame) expressed as the value at 1m from air inlet side varies for each model (non-condensing) 30 ? to 70 ? non-condensing inlet : redy ? blackysensor: yellow control: brown outlet : orangey ? grayysensor: purple control: white approx. 1,600g speci?cations features counter rotating fan 172 1 62 ? 0.5 1 72 ? 0.8 (1 0) (1 0) 4- 4.5 ? 0.3 7 .5 ? 0.4 1 02 ? 1 7 .5 ? 0.4 1 50 ? 0.8 4- 4.5 ? 0.3 55.5 ? 55.5 ? a wg22 ul1430 +30 30 0 0 +30 30 0 0 counter rotating fan 172mm [m 3 /min] [cfm] [pa] [inchh 2 o] | db(a) [ ? ] [ h ] model no. rated voltage | v operating voltage range |v rated current | a rated input | w common speci?cations rated speed | min -1 i n l e t o u t l e t max. air flow max. static pressure spl operating temperature expected life n o t e ) pwm duty cycle | % note : pwm frequency 25khz rotating direction rotating direction air flow direction inlet side outlet side inlet side , outlet side mounting hole mounting hole reference dimension of mounting holes and vent opening (unit : mm) dimensions (unit : mm) l e a d w i r e 1-15-1, kita-otsuka, toshima-ku,tokyo 170-8451, japan. phone :+ 81 3 3917 5151 http://www.sanyodenki.com the names of companies and/or their products speci?ed in this catalog are the trade names, and/or trademarks and/or registered trademarks of such respective companies. speci?cations are subject to change without notice. ? the products shown in the catalog are subject to japanese export control law. diversion contrary to the law of exporting country is prohibited. ? to protect against electrolytic corrosion that may occur in locations with strong electromagnetic noise, we provide fans that are unaffected by electrolytic corrosion. catalog no. c1012 b 001 ?12.08 www.datasheet.net/ datasheet pdf - http://www..co.kr/
|
